1. HOME
  2. Products
  3. Moving Probe Tester
  4. Line Up
  5. E4M8161

M Series

E4M8161

Model best suitable for testing larger size boards (burn-in and backplane boards). Despite its greater size, high speed testing is still secured with higher alignment accuracy.

Specifications
Max. Test Area32 x 24" (810x610mm) *1
Number of Probes2 Front, 2 Rear
Min. Board Size2.4 x 2.6" (60x65mm)
Max. Board Thickness for Clamping0.354" (9mm)
Untestable Area1mm from edge of clamp area *2
Repeatable Accuracy±0.16mil (±4µm)
Resolution0.08mil (2µm)
Min. Pad Pitch *34.8mil (120µm)
Min. Pad Size *41.2mil (30µm)
Test Voltage of Resistance MeasurementContinuity test: 0-10V
Isolation test: 250V(500V/1000V option)
Test Current of Resistance MeasurementContinuity test: 2.5µA-150mA
Clamp SystemPneumatic (Side clamp is option)
CCD Camera2 Front, 2 Rear
PrinterExternal
Air RequirementsPressure: 0.5MPa, Consumption: 0.12ft³/min.(3.5ℓ/min.)
Power Supply *515A (Single Phase AC200-240V 50/60Hz)
Weight3131lbs. (1420kg)
DimensionsDimensions
*1Area will be 770x610mm when using side clamp (optional).
*2With needle probes. Value shall change when other probes are used.
*3With T96MC-PB-0R40 probe.
*4With T96MC-PB-0B00 probe.
*5Power Supply: There may be cases with inrush current equaling to 10 times of the rated and flowing when the power is turned ON. Please choose the breaker that will not cause any malfunction by such inrush current.
System Requirements
System Requirements1) Control PC & Monitor
2) PC & Monitor for Test Data Editing.
1) and 2) can be completed in one PC.
* Please inquire our sales for PC specification.
Probe TypeUsers can choose one of different types of probes depending on tester models. Please ask our sales for specifications of each probe & PC.
SoftwareEMMA2010 for Control PC is included,
but all other software is optional (supporting OS are
Windows 7 / Windows 8 / Windows 10).
Operating Conditions· 70-75°F (21-24°C), 30-70% relative humidity
Do not use under the environment that has heavy condensing, dust, vibration, and/or corrosive gas.
· Atmospheric Dew Point: -14°C or below (at 0.7Mpa, dew point is 15°C or below)
· Oil Mist Concentration: 1mg/㎥ (ANR) or below